Skip to content

Heat Pump Hot Water Jewells

Heat pump hot water for Jewells homes means we price, supply and fit an air-sourced unit in place of your old electric cylinder, with a temporary tank running while the changeover happens. The full price is settled before you agree to go ahead. Ring or send the form and a plumber comes out to measure up.

The full service picture. Repairs, replacements and every other system type sit on our hot water services page, and the plumber in Jewells home page covers gas, drains and the rest.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Storage hot water unit fitted against a house wall
Newly installed storage hot water unit

Why trade a cylinder for a heat pump?

How the unit works. A heat pump works like a fridge run backwards. A fan draws outdoor air across a coil, the heat in that air is moved into the water, and the tank stores it for the taps.

That suits this coast. Mild, humid air carries plenty of heat even in winter, so the compressor has warmth to work with on days an old element would be drawing hard from the grid.

What changes for the household:

  • Lower running costs than an old electric storage unit
  • No gas supply needed, so it suits blocks without a gas main
  • The same taps and pipework inside, with no bathroom work
  • An outdoor unit that sits on a small slab or pad

If gas already reaches your meter, a continuous-flow gas unit is worth pricing alongside it, and the gas fitting side of the business connects that option too.

Electric storage hot water unit after installation

What feeds the figure on a heat pump?

On a heat pump, the unit and where it sits drive most of the number:

  • The unit's size and brand tier, since a bigger household needs a bigger tank
  • The spot the unit lands on, and how far pipe has to run to reach it
  • Any electrical work the unit calls for, which an electrician quotes separately
  • A changeover booked for a night or weekend, which runs at the after-hours rate

The plumber measures all of that on site before naming a figure.

How the swap runs on site

  1. 01

    Ring or send the form

    Call (02) 4063 3469 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 02

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 03

    Drain, mount and connect

    The old cylinder is drained and removed, the heat pump goes on its pad with room for air to move, and the plumbing is connected, filled and tested hot.

  4. 04

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

A unit that quits on a Sunday is an after-hours emergency, and that page is answered at any hour.

Where the swap suits the local housing

One build wave, one upgrade wave

Jewells was subdivided in the 1920s but only filled with brick-veneer homes from the 1970s on, so the first cylinders and the ones that replaced them are wearing out in the same few years. The area-level count of heat pump units installed around here stands at 1,369, so the switch is well tested nearby.

Salt sits on anything left outside

Retirement villas off Ntaba Road, built in brick, take the same onshore wind as every detached house on the sandy blocks. A heat pump's coil lives in that wind all year, so we site it with airflow and some shelter in mind rather than bolting it to the first bare wall.

When we're not the right call

A heat pump that needs its own new circuit at the switchboard has an electrical side, and that goes to a licensed electrician before the plumbing is finished. A storm-damaged roof dripping onto the unit is a roofer's repair. The water side is ours.

What Customers Say

[The plumber] & his young helper were courteous, well mannered & competent when replacing the solar hot water station pump at my property
Jennifer

Heat Pump Questions From Jewells Homes

Is a heat pump a good fit for an older Jewells home?

The homes here went up from the 1970s on, so an original or second cylinder is due for retirement anyway. A heat pump can reuse the existing hot and cold pipework inside, and the plumber checks on the visit whether the switchboard needs a dedicated circuit.

Does the salt air off Nine Mile Beach shorten a heat pump's life?

Salt is hard on any metal left outdoors, and a heat pump's fan and coil live outside full time. We mount the unit clear of the ground, with airflow on the more sheltered side of the house where possible, and a yearly service keeps the coil and casing ahead of the corrosion.

Will we have hot water while the swap happens?

Yes. A temporary tank supplies the showers and taps while the heat pump is on order or being fitted, so the household is not left with cold water. It comes out once the new unit is connected, tested and running hot.

Is the heat pump install covered by your warranty?

Every job carries our 365-day warranty on all work. If something we installed is not right within that year, ring the same number and we come back and sort it.

Need a plumber? Call or send the form

Call (02) 4063 3469 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 3469

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 3469 Get a quote